Rectangular ducting

Rectangular ductwork fittings, each side drawn as its own flat plate with the bend lines: straight duct, reducers, offsets, radiused or mitred elbows at any angle, branches, Y pieces and a splitter. For a square to round, see the transitions.

Straight duct

Straight rectangular duct sections made of four plates. Flat plates.

Duct reducer

Rectangular duct reducers, centred, with one side straight, or offset. Flat plates.

Duct offset

Rectangular duct offsets (jogs) that move the duct sideways, with square or radiused turns. Flat plates.

Duct branch

Rectangular duct branches and take-offs, square or angled, with sharp or rounded corners. Flat plates.

Duct Y

Rectangular duct Y-pieces that split one duct into two. Flat plates.

Duct splitter

Rectangular duct splitters with one leg bent away. Flat plates.

Duct elbow

Rectangular duct elbows, radiused or mitred, at any angle. Flat plates.

How the pattern is developed

Flat plates

The part is made of flat plates joined at their edges. Each plate is drawn at its true shape with the bend or seam lines marked, so the plates can be cut and folded or welded without measuring on the part.

Questions

Why is a rectangular duct drawn as plates?

Rectangular duct is folded or seamed from flat sheet, so each side is drawn at its true shape, with its bend lines, ready to cut and fold.

Which duct parts are there?

Straight duct, reducers, offsets, elbows (radiused or mitred, at any angle), branches, Y pieces and a splitter.

How are a radiused elbow’s parts laid out?

The cheeks are flat plates with their arcs; the throat and the heel are strips at their true length.