Oval segmented bend on its side with extended ends
The oval-on-its-side bend with straight extensions on the end segments, so the fitting brings its own tangents. Start and end extensions are set separately.
Oval segmented bend on its side through any angle whose first and last segments run on straight past the bend.
Sizes you enter
- Oval width (W): Across the bend: the short side, the diameter of the half rounds.
- Oval height (H): In the plane of the bend: the long side, half rounds facing the inside and outside of the bend.
- Centre-line radius (R): From the bend centre to the duct centre line.
- Bend angle (A): How far the duct turns, more than 0° up to 180°.
- Start extension (E1): Straight run of the first segment before the bend.
- End extension (E2): Straight run of the last segment after the bend.
- Number of segments (n): All segments, the two end segments included.
What you get
The exact flat pattern of the part, worked out for the sheet thickness measured on the inside, the mean or the outside, with numbered press lines, the part in 3D, its weight and cutting length, and a DXF for laser, plasma or waterjet cutting (STEP as well).