Pipe into elbow at an angle: branch pattern
The branch enters the outside of the elbow turned out of the bend's plane, as seen in plan. You set the pipe angle, where its axis crosses the bend, and the offset up.
A round pipe set into the outside of a 90° bend, turned from the bend's plane as seen from above; the pattern is the pipe.
Sizes you enter
- Pipe diameter (D): Across the pipe, on the surface chosen under Sheet.
- Bend radius (R): From the centre of the bend's arc to its centre line.
- Bend diameter (Db): Across the bend, on the surface chosen under Sheet; the pipe sits on its outside.
- Offset up (E): The pipe's centre line above the centre line of the bend's level end.
- Pipe angle (A): Seen from above: between the pipe and the bend's centre plane.
- Crossing point (X): Seen from above: where the pipe's centre line crosses the bend's, measured from the bend's level end.
- Pipe length (L): From the crossing point to the pipe's open end, along the pipe.
What you get
The exact flat pattern of the part, worked out for the sheet thickness measured on the inside, the mean or the outside, with numbered press lines, the part in 3D, its weight and cutting length, and a DXF for laser, plasma or waterjet cutting (STEP as well).