Oblique cone flat pattern, one side upright
An eccentric reducer: a cone whose top is pushed to one side until that side stands square to the base. Laid out in one part, seamed on the upright side, or in two halves with seams on both sides. The press lines run along the cone's true straight lines, each its own length.
A cone with its top pushed to one side until that side stands square to the base: an eccentric reducer.
Sizes you enter
- Base diameter (D): The larger end, on the surface chosen under Sheet.
- Top diameter (d): The smaller end, on the same surface.
- Height (H): From the base to the top, along the upright side.
What you get
The exact flat pattern of the part, worked out for the sheet thickness measured on the inside, the mean or the outside, with numbered press lines, the part in 3D, its weight and cutting length, and a DXF for laser, plasma or waterjet cutting (STEP as well).