Pipe to cone, angled branch pattern
The angled branch on a cone, its end shaped to the cone surface. Use it with the matching cone page for the hole.
A round branch rising out of a cone at an angle, on its centre line or off it; the pattern is the branch.
Sizes you enter
- Base diameter (D): Across the cone's base, on the surface it is drawn to.
- Top diameter (d): Across the cone's top, on the surface it is drawn to.
- Height (H): From the base to the top.
- Branch diameter (Db): Across the branch, on the surface chosen under Sheet.
- Branch height (Hb): From the base to where the branch's centre line meets the cone's.
- Branch angle (A): The branch's centre line above the level, rising outwards (0 = level).
- Offset (Z): The branch's centre line to the side of the cone's (0 = on it), seen from above.
- Branch length (L): Along the branch's centre line, from where it meets the cone's to the open end.
What you get
The exact flat pattern of the part, worked out for the sheet thickness measured on the inside, the mean or the outside, with numbered press lines, the part in 3D, its weight and cutting length, and a DXF for laser, plasma or waterjet cutting (STEP as well).