Press brake profiles
Parts bent on a press brake, worked out as one flat blank with the bend allowance of every bend and the bend lines. K follows DIN 6935 unless you give your own K or your shop's bend deduction; Settings keeps them per material and thickness.
Press brake profile
Angles, channels, Z purlins and hat sections bent on the press brake: brackets, frames, stiffeners, cable trays, cladding and roofing trims. Bending on the press brake.
- Press brake profile, L (angle)
- Press brake profile, U (channel)
- Press brake profile, Z
- Press brake profile, Offset (step)
- Press brake profile, Hat (omega)
- Press brake profile, Lipped C
How the pattern is developed
Bending on the press brake
A profile bent on a press brake is cut as one flat blank. Its width is the sum of the straight legs plus, at each bend, the length of the neutral layer through the bend: the angle turned times (Ri + K·t). K sets where the neutral layer lies; it follows DIN 6935 from the inside radius and the thickness unless the shop gives its own K, or its bend deduction from a test bend. Each bend line is drawn at the middle of its bend, marked up or down.
Questions
How is the flat blank of a bent profile worked out?
The straight legs between the bends plus each bend's allowance, the angle turned times (Ri + K × t). With outside sizes two setbacks come off at each bend; the result is the sum of the outside legs less one bend deduction a bend.
Which K factor should I use?
Leave K at 0 and Unfoldo takes it from DIN 6935, from the inside radius against the thickness: 0.5 from Ri = 5t up, less for tighter bends. If your shop knows its own K, or its bend deduction from a test bend on its press, enter that and it is used instead.
Where is the bend line drawn?
At the middle of each bend on the blank, marked up or down with its angle and inside radius, on its own layer of the DXF, so the blank can be lined up on the brake.