Oblique cone flat patterns, in levels
A long oblique reducer made in rings: the cone, its top moved off the base's centre across and back, is cut across into levels of equal height, each rolled as its own part. Every level is a slice of the same cone, its press lines along the cone's true straight lines.
An oblique cone, its top off the base's centre both ways, cut across into levels of equal height, each rolled as its own part.
Sizes you enter
- Base diameter (D): The larger end, on the surface chosen under Sheet.
- Top diameter (d): The smaller end, on the same surface.
- Height (H): From the base to the top.
- Top offset across (X): From the base's centre to the top's, seen from the front: to the left. Negative: to the right.
- Top offset back (Y): From the base's centre to the top's, seen from above, square to X: toward the back. Negative: toward the front.
- Levels (Lv): Number of levels the cone is cut into across, all the same height.
What you get
The exact flat pattern of the part, worked out for the sheet thickness measured on the inside, the mean or the outside, with numbered press lines, the part in 3D, its weight and cutting length, and a DXF for laser, plasma or waterjet cutting (STEP as well).