Rectangle to cone, angled branch: cone pattern
A rectangular duct with rounded corners rises into a cone at an angle, on its centre line or off it, as on an inclined take-off from a hopper or a conical hood. The cone is developed flat with the exact hole the duct cuts in it.
A rectangular duct rising at an angle into a cone, on its centre line or off it; the pattern is the cone with its hole.
Sizes you enter
- Base diameter (D): Across the cone's base, on the surface chosen under Sheet.
- Top diameter (d): Across the cone's top, on the surface chosen under Sheet.
- Height (H): From the base to the top.
- Duct width (W): Across the duct, seen from above; the hole is cut to the duct as given.
- Duct height (Hr): The duct from its bottom to its top, square to its centre line.
- Corner radius (r): The duct's corners, seen end on (0: sharp).
- Duct height up the cone (Hb): From the base to where the duct's centre line meets the cone's.
- Duct angle (A): The duct's centre line above the level, rising outwards (0 = level).
- Offset (Z): Seen from above: the duct's centre line to the side of the cone's (0: on it).
What you get
The exact flat pattern of the part, worked out for the sheet thickness measured on the inside, the mean or the outside, with numbered press lines, the part in 3D, its weight and cutting length, and a DXF for laser, plasma or waterjet cutting (STEP as well).