Mitred elbow, pipe to pipe, any angle: flat patterns
Two round pipes meet at one mitre joint at whatever angle the run needs, from a slight offset to a sharp turn. Both pipes are developed flat, with the seams on the same side or staggered so the patterns nest.
Two pipes meeting at one mitre joint, turning the run through any angle; the patterns are both pipes.
Sizes you enter
- Diameter (D): Across the pipes, on the surface chosen under Sheet.
- First leg (L1): From the first pipe's open end along its centre line to where the centre lines meet.
- Second leg (L2): From the second pipe's open end along its centre line to where the centre lines meet.
- Angle between the pipes (A): Between the two centre lines where they meet, more than 0° and less than 180° (90°: a square elbow; less: a sharper turn).
What you get
The exact flat pattern of the part, worked out for the sheet thickness measured on the inside, the mean or the outside, with numbered press lines, the part in 3D, its weight and cutting length, and a DXF for laser, plasma or waterjet cutting (STEP as well).