Rectangle to round transition with angled base
Here the rectangular end sits on a slope, for example on a pitched roof or an inclined hopper side, while the round top stays level. The top can be offset along both sides of the base.
The base is inclined; the round top stays level and may be moved off centre.
Sizes you enter
- Base width (W): Side of the base along the tilt axis.
- Base length (L): Side of the base along the slope, measured on the slope.
- Top diameter (D): Must be smaller than both base sides.
- Height (H): Vertical distance from the centre of the base to the top.
- Base angle (β): Slope of the base from the horizontal, seen from the front.
- Top offset along the length (X): Moves the top centre along L, measured level (in plan). 0 = centred.
- Top offset along the width (Y): Moves the top centre along W. 0 = centred.
- Base corner radius (R): 0 = sharp corners.
What you get
The exact flat pattern of the part, worked out for the sheet thickness measured on the inside, the mean or the outside, with numbered press lines, the part in 3D, its weight and cutting length, and a DXF for laser, plasma or waterjet cutting (STEP as well).