Rectangle to round transition with angled top
The round end is inclined to the base, for a pipe that leaves the fitting at an angle. The top can also be moved off centre. Height is measured to the centre of the tilted top.
The round top is tilted, and may also be moved off centre.
Sizes you enter
- Base width (W): Shorter side of the base.
- Base length (L): Longer side of the base.
- Top diameter (D): Must be smaller than both base sides.
- Height to top centre (H): From the base to the centre of the round top.
- Top angle (α): Angle between the top and the base, seen from the front. 0 = top parallel to the base.
- Top offset along the length (X): Moves the top centre along L. 0 = centred.
- Top offset along the width (Y): Moves the top centre along W. 0 = centred.
- Base corner radius (R): 0 = sharp corners.
What you get
The exact flat pattern of the part, worked out for the sheet thickness measured on the inside, the mean or the outside, with numbered press lines, the part in 3D, its weight and cutting length, and a DXF for laser, plasma or waterjet cutting (STEP as well).