Pipe to oblique cone: upright branch pattern
The vertical branch on an eccentric cone, its lower end shaped to the cone surface. Use it with the matching cone page for the hole.
A round branch standing upright (square to the base) on an oblique cone, anywhere on it; the pattern is the branch.
Sizes you enter
- Base diameter (D): Across the cone's base, on the surface it is drawn to.
- Top diameter (d): Across the cone's top, on the surface it is drawn to.
- Height (H): From the cone's base to its top.
- Top offset (X): The top's centre from the base's, seen from above: away from the branch's side (negative: towards it).
- Branch diameter (Db): Across the branch, on the surface chosen under Sheet.
- Branch position (Xb): From the base's centre out to the branch's centre line, on the side the top leans away from.
- Offset (Z): The branch's centre line to the side (0 = straight out from the base's centre), seen from above.
- Branch top (Ht): From the cone's base up to the branch's open end.
What you get
The exact flat pattern of the part, worked out for the sheet thickness measured on the inside, the mean or the outside, with numbered press lines, the part in 3D, its weight and cutting length, and a DXF for laser, plasma or waterjet cutting (STEP as well).