Lateral pipe trunk pattern with branch hole
The trunk of a lateral or angled tee developed flat, with the elongated hole for the branch cut out. Set the angle and any offset of the branch.
A round branch into a round trunk at any angle, on its centre line or off it; the pattern is the trunk with its hole.
Sizes you enter
- Trunk diameter (Dt): Across the trunk, on the surface chosen under Sheet.
- Branch diameter (Db): Across the branch, on the surface chosen under Sheet.
- Trunk height (H): Overall height of the trunk.
- Branch height (Hb): From the trunk's bottom to where the branch's centre line meets the trunk's.
- Angle (A): Between the branch's centre line and the trunk's below it (90° = square).
- Offset (Z): Seen from above: the branch's centre line off the trunk's (0: on centre).
What you get
The exact flat pattern of the part, worked out for the sheet thickness measured on the inside, the mean or the outside, with numbered press lines, the part in 3D, its weight and cutting length, and a DXF for laser, plasma or waterjet cutting (STEP as well).